Skip to content Skip to sidebar Skip to footer

How To Remove Rusted Body Mount Bolts Jeep Tj


How To Remove Rusted Body Mount Bolts Jeep Tj. Or seal with silicone so you can access it down the road. Drilling the floorboard holes and soaking the bolts from above with kroil is almost a sure fire way to get them out.

How to replair rusted off body mounts
How to replair rusted off body mounts from www.jeepforum.com

I tried drilling the one i broke out but the hardened steel won't drill. John in the woods, akcj2a and blade1668. Jeep tj rear upper shock mount bolt head gone.

Use A Punch To Hammer In The Center Of The Bolt Head To Help Break The Joint.


Some broke the nuts loose where they are welded inside the body and had to be cut off. Or seal with silicone so you can access it down the road. Put a breaker bar and socket.

Jeep Tj Rear Upper Shock Mount Bolt Head Gone.


From the factory the shocks are installed on the assembly line, likely before the body is on the jeep. I went to pull out my body mounts to install a 1 body lift and broke one of them (rear right). Then, gentle apply steady torque to the socket from a 24 inch hf breaker bar is called for here.

These Bolts Are Notorious For Breaking And Needing Drilled.


Several bolts broke as they had rusted out inside the rubber washers. 2012 black jk 2018 white grand cherokee, 2001 tj, 2020 jlur ecodiesel vehicle showcase 1. These two in the rear were so rusted that the diameter of bolt at the breaking point was close to half that at the head.

I Firmly Believe How You Leverage Your Breaker Bar When Removing These Bolts Is Critical Due To The Hole Being Larger Than The Bolt Itself.


I would add that if/when you encounter significant resistance, turn the bolt back in a little, and take a break from that bolt for a bit. The bolt heater will help later for any rusted or seized bolts on later installs. How do you guys remove broken rusted body mount bolts?

Some Looked Good But When I Started To Remove The Bolts For The Body The Real Problems Came Out.


Then you simply add a washer and nut to tighten the new bolt in place. In this video i show how to. If the bolt snaps because of rust you have to cut a hole in the tub to get the broken bolt out.


Post a Comment for "How To Remove Rusted Body Mount Bolts Jeep Tj"